VeriFone VX 520 Installation Guide download pdf (Page 27)

TERMINAL SETUP

VX 520 Setup

VX 520 I

NSTALLATION GUIDE 27

Optional Device Connections

The VX 520 terminal has a port that can operate either as a PIN pad port or an

RS-232 port, depending on the power source available.

Connecting the PIN

pad or Smart Card

Reader to the VX 520

Use the following procedures to connect a PIN pad or smart card reader.

1 Remove the VX 520

terminal rear cover.

2 Insert the RJ-45-type connector of the PIN pad or smart card reader into the

port of the peripheral device.

To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the

grommet to secure the cable connection.

If a cable is not already connected to the smart card reader or PIN pad, insert

the small modular plug on one end of the interface cable into the optional

device’s modular jack.

3 Insert the larger RJ-45-type connector on the other end of the PIN pad cable

into the PIN pad serial port on the terminal. Figure 14 provides an example of

a smart card reader and PIN pad connection to the PIN pad serial port.

Figure 14 VX 520 Sample PIN Pad Connection

NOTE

When the VX 520 terminal is powered via the corded power supply, the terminal

provides 4.0 A at 9.3V DC. This power will drive most VeriFone accessories.

Contact your local VeriFone representative for more information.

23

%4(

RS-232

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 63 64

No comments

VeriFone VX 520 Installation Guide Page 27