VeriFone Omni 3200M Installation Guide download pdf (Page 26)

Omni 3200M Installation Guide

5. If necessary, hold down the paper feed button until about

5 centimeters (2 inches) of paper emerge from the slot

below the serrated metal tear strip.

6. Insert the orange plastic spindle into the hole in the paper

roll you are holding. Then, place the spindle and roll into

the paper roll cradle so the ends of the spindle rest

securely in the two slots.

7. Replace the paper roll cover by inserting its two front tabs

into the slots on either end of the serrated metal strip and

then lightly pushing down on the back of the cover until it

snaps into place.

(Remember to lift up the end of the paper roll when

replacing the paper roll cover so that the paper rests on top

of the cover.)

Note: The integrated printer has a paper feed release lever that

lets you manually adjust the position of the paper you have

loaded into the printer (see Figure 15). To do this, lift up on the

small red lever located on the right side of the paper roll cradle

until it snaps into its “up” position. You can now freely move

the paper up and down through the feed mechanism. When the

paper is in the correct position, lower the lever until it snaps

into its “down” position.

Performing a Power-On Printer Test

When you have installed a paper roll, you can perform a quick

test to make sure the printer is operating correctly:

1. Temporarily disconnect the terminal from its power source

by removing the power connector from the power port on

the back panel. (Twist the connector to the right to unlock

it and then pull it straight out.)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 40 41

No comments

VeriFone Omni 3200M Installation Guide Page 26