VeriFone Omni 3200M Installation Guide download pdf (Page 25)

Omni 3200M Installation Guide

Caution: Because impact, friction, temperature, humidity,

light, and oil affect the coloring and storage characteristics of

thermal paper, handle this type of paper carefully. Never load a

roll of paper that has folds, wrinkles, tears, or holes at edges or

in the printing area. For best results, cut the leading edge of the

paper with scissors, instead of tearing it, before feeding it into

the printer.

Installing a Paper Roll

To install a roll of thermal printer paper in the Omni 3200M:

1. Be sure the terminal is connected to a power source. (The

green LED light should be blinking off and on, indicating

that the printer needs paper.)

2. With the terminal on a flat surface, and facing toward you,

remove the paper roll cover from the top of the terminal by

lifting up on the back of the cover. The two ridges on each

side of the black plastic cover show you where to grasp it.

3. Remove the protective strip from a new roll of paper and

cut a clean, straight edge on the leading end of the paper.

4. Holding the roll in your hand with the paper feeding from

the bottom of the roll, slowly insert the leading end into

the paper feed slot (see Figure 15).

When the built-in sensor detects the paper, the feed

mechanism engages and pulls the paper into the printer,

ejecting the end out of the top of the printer, just below the

serrated metal tear strip.

Note: The paper feed slot is located directly above the gray

plastic paper roll cradle, and below the black plastic ridge that

extends slightly from the base of the paper feed mechanism.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

No comments

VeriFone Omni 3200M Installation Guide Page 25