9
Omni 3200M Installation Guide
Step 4: Connect the Antenna to the Antenna Base
Follow these steps to connect the antenna to the antenna base
located on the back panel of the terminal (see Figure 6):
1. Holding the middle part of the antenna with the rubber
whip pointing upward, position the bottom of the antenna
onto the threaded connector post of the antenna base.
Carefully insert the “male” connector pin that is inside the
antenna into the gold-colored “female” receptacle in the
center of the post. (The hole in the bottom of the rubber
antenna sleeve lets you move the antenna into position.)
2. With the antenna in a vertical position, gently turn it in a
clockwise direction until it is fastened securely to the
antenna base. Tighten only until “hand tight.”
Figure 6 Connecting the Antenna
Comments to this Manuals