VeriFone Omni 3200 Specifications download pdf (Page 122)

Omni 3200 Reference Manual

106 Performing Remote Diagnostics

Setting Up the Terminal

Before you can perform a remote diagnostics session over a telephone

line connection, the following requirements must be met:

• The Omni 3200 terminal must be connected to a dial-up

telephone line.

• The remote diagnostic computer must be set up and ready to

receive a telephone request from the Omni 3200 terminal.

• The telephone number of the remote diagnostic computer number

must be stored in a keyed record in the terminal’s CONFIG.SYS

file under the record key, *T.

Note: If the *T record is not present in the CONFIG.SYS file when

you start remote diagnostics, you will be prompted to enter the

telephone number during the procedure.

• To select a specific baud rate for the diagnostics session, you can

include a *RDR record in the CONFIG.SYS file of the terminal

to be diagnosed. The *RDR record is optional. If the remote

computer does not detect the *RDR record when it dials up the

terminal, it uses the default value of 2400 baud (*RDR= 3).

Possible values for *RDR include the following:

00 = 300

01 = 600

02 = 1200

03 = 2400

04 = 4800

05 = 9600

06 = 19200

Note: Because *RDR is an optional value, you will not be prompted

to enter this keyed record during the diagnostics procedure described

in Table 26 below.

O3200 RM Book.book Page 106 Thursday, April 29, 1999 3:48 PM

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 200 201

No comments

VeriFone Omni 3200 Specifications Page 122